Toshiba e-STUDIO200L, Service Manual

Page: 41 / 708

June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 5
2
E910 Finisher jam
(Bridge unit) Jam at the bridge unit transport sensor-1: The
paper does not reach the bridge unit transport sen-
sor-1 after it has passed the exit sensor. P. 5-35
E920 Stop jam at the bridge unit transport sensor-1: The
trailing edge of the paper does not pass the bridge
unit transport sensor-1 after its leading edge has
reached the sensor. P. 5-35
E930 Jam at the bridge unit transport sensor-2: The trail-
ing edge of the paper does not reach the bridge unit
transport sensor-2 after its leading edge has
reached the bridge unit transport sensor-1. P. 5-35
E940 Stop jam at the bridge unit transport sensor-2: The
trailing edge of the paper does not reach the bridge
unit transport sensor-2 after its leading edge has
reached the bridge unit transport sensor-2. P. 5-35
E950 Job separator jam Jam not reaching the job separator transport sen-
sor: The paper has passed through the exit sensor
does not reach the job separator transport sensor. P. 5-11
E951 Stop jam at the job separator transport sensor: The
trailing edge of the paper does not pass the job sep-
arator transport sensor. P. 5-11
E960 Offset tray jam Jam not reaching the offset tray transport sensor:
The paper has passed through the exit sensor does
not reach the offset tray transport sensor. P. 5-11
E961 Stop jam at the offset tray transport sensor: The
trailing edge of the paper does not pass the offset
tray transport sensor. P. 5-11
E9F0 Finisher jam
(Puncher unit) Punching jam: Punching is not performed properly.
[MJ-1025 (When MJ-6005 is installed)] P. 5-36
EA10 Finisher jam
(Finisher unit) Paper transport delay jam: The paper which has
passed the bridge unit does not reach the inlet sen-
sor. [MJ-1022/1025] P. 5-37
EA20 Paper transport stop jam: The paper does not pass
through the inlet sensor. [MJ-1022/1025] P. 5-38
EA30 Power-ON jam: Paper exists at the inlet sensor
when power is turned ON. [MJ-1022/1025] P. 5-39
EA40 Door open jam: The finisher has been released
from the equipment during printing. [MJ-1022/1025] P. 5-40
EA50 Stapling jam: Stapling is not performed properly.
[MJ-1022/1025] P. 5-41
EA60 Early arrival jam: The inlet sensor detects the paper
earlier than a specified timing. [MJ-1022] P. 5-42
EA70 Stack delivery jam: It cannot deliver the stack of
paper on the intermediary process tray to the stack
tray. [MJ-1022/1025] P. 5-43
EAB0 Finisher jam
(Saddle Stitcher sec-
tion) Saddle paper transport stop jam: The paper which
passed through the inlet sensor does not reach or
pass through the folding position sensor. [MJ-1025] P. 5-45
EAC0 Saddle transport delay jam: The paper which has
reached the inlet sensor does not pass through this
sensor. [MJ-1025] P. 5-45
EAD0 Other paper jam Print end command time-out jam: The printing has
not finished normally because of the communica-
tion error between the SYS board and LGC board
at the end of printing. P. 5-46
Error code Classification Contents Troubleshooting