Toshiba e-STUDIO200L, Service Manual

Page: 40 / 708

e-STUDIO200L/202L/230/232/280/282 ERROR CODE AND SELF-DIAGNOSTIC MODE June 2004 © TOSHIBA TEC
2 - 4
E711 RADF jam Jam not reaching the original length sensor: The
original fed from the original feeding tray does not
reach the original length sensor. P. 5-28
E712 Jam not reaching the registration sensor: The origi-
nal fed from the original feeding tray does not reach
the registration sensor. P. 5-28
E713 Stop jam at the original length sensor: The trailing
edge of the original does not pass the original
length sensor after its leading edge has reached
this sensor. P. 5-28
E714 Feed signal reception jam: The feed signal is
received even no original exists on the original
feeding tray. P. 5-29
E721 Jam not reaching the read sensor: The original
does not reach the read sensor after it has passed
the registration sensor (when scanning obverse
side) or the reverse sensor (when scanning reverse
side). P. 5-29
E722 Jam not reaching the exit sensor (during scanning):
The original which passed the read sensor does not
reach the exit sensor when it is transported from the
scanning section to exit section. P. 5-30
E723 Jam not reaching the reverse sensor (during scan-
ning): The original which passed the read sensor
does not reach the reverse sensor when it is trans-
ported from the scanning section to reverse section. P. 5-30
E724 Stop jam at the registration sensor: The trailing
edge of the original does not pass the registration
sensor after its leading edge has reached this sen-
sor. P. 5-30
E725 Stop jam at the read sensor: The trailing edge of the
original does not pass the read sensor after its lead-
ing edge has reached this sensor. P. 5-31
E726 Transport/exit signal reception jam: RADF receives
the transport/exit reception signal from the equip-
ment when no original is at the exposure waiting
position. P. 5-31
E731 Stop jam at the exit sensor: The trailing edge of the
original does not pass the exit sensor after its lead-
ing edge has reached this sensor. P. 5-32
E741 Stop jam at the reverse sensor: The trailing edge of
the original does not pass the reversal sensor after
its leading edge has reached this sensor. P. 5-32
E742 Jam not reaching the reverse sensor (during
reverse feeding): The leading edge of the original
does not reach the reverse sensor when original is
fed from the reverse section. P. 5-33
E743 Jam not reaching the exit sensor (during reverse
feeding): The original does not reach the exit sen-
sor after it has passed the reverse sensor when the
original is exited from the reverse section. P. 5-33
E860 RADF jam access cover open: The RADF jam
access cover has opened during RADF operation. P. 5-34
E870 RADF open jam: RADF has opened during RADF
operation. P. 5-34
Error code Classification Contents Troubleshooting