TM 11-6625-3145-14
Maintenance: Troubleshooting-318/338 Service
3.
All character fonts for the parallel analyzer mode. To check the CRT circuit and the Character ROM (CROM) for
parallel operation.
4.
All character fonts for the serial state analyzer mode. To check the CRT circuit and the CROM for serial operation.
Description: Refer to Figure 7-34. The CRT displays 32 characters by 20 lines of data from the Display RAM U515 (16 K-
bit static CMOS RAM, uPD446/HM6116P) on the A06 MPU/Display board. Each character in the CRT display uses two
bytes of data, consisting of one selection code followed by one character code. A total of 1280 bytes of the Display RAM
are used, ranging from address E800 to ECFF.
The MPU writes these two bytes of data for each character to be displayed into the Display RAM through both U525 (octal
bus transceiver, 40H245) and U500 (display controller, MB62110) on the A06 board.
The Display Controller sends the first address to the Display RAM to select the character code to be displayed, and
instructs U520 (octal D type flip-flop, 40H273) on the A06 board to store the out-put data from the Display RAM. This data
is supplied to the Character ROM U530 (32 K-bits mask ROM, 2332) on the A06 board to select the character font. The
Display Controller receives this font code and sends the second address to the Display RAM to get a control code.
The Display Controller then issues Z, GLITCH, CHD, and VD signals to the A10 CRT board, along with these two bytes of
data. These signals are buffered and/or controlled and sent to the A10 board through the A08 Mother board.
4434-556
Figure 7-34. 338 CRT calibration and check schematic.
7-97
Summary of Contents for 318
