Siemens RUGGEDCOM ROX II, User Manual

Page: 406 / 798

Chapter 12
Tunneling and VPNs
RUGGEDCOM ROX II
CLI User Guide
360 Deleting a Virtual Switch
5. If
ip-address-src
or
ipv6-address-src
is set to
static
, assign an IP address to the virtual switch if
required. For more information, refer to either Section 7.1.3.2, “Adding an IPv4 Address” or Section 7.1.4.2,
“Adding an IPv6 Address” .
6. [Optional] Assign one or more VLANs to the virtual switch. For more information, refer to Section 12.1.8.2,
“Adding a Virtual Switch VLAN” .
7. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 12.1.3
Deleting a Virtual Switch
To delete a virtual switch, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the chosen virtual switch by typing:
no interface virtualswitch
name
Where:
•
name
is the name assigned to the virtual switch
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 12.1.4
Managing Virtual Switch Interfaces
This section describes how to configure and manage interfaces for virtual switches.
CONTENTS
• Section 12.1.4.1, “Viewing a List of Virtual Switch Interfaces”
• Section 12.1.4.2, “Adding a Virtual Switch Interface”
• Section 12.1.4.3, “Deleting a Virtual Switch Interface”
Section 12.1.4.1
Viewing a List of Virtual Switch Interfaces
To view a list of virtual switch interfaces, type:
show running-config interface virtualswitch name interface
Where:
•
name
is the name assigned to the virtual switch
If virtual switch interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config interface virtualswitch vs1 interface | tab
NAME
-----------------
switch.0100
te1-4-1c01.0100