Siemens RUGGEDCOM ROX II, User Manual

Page: 734 / 798

Chapter 16
Traffic Control and Classification
RUGGEDCOM ROX II
CLI User Guide
688 Configuring Port Mirroring
• Section 16.1.3, “Managing Ingress Source Ports”
Section 16.1.1
Configuring Port Mirroring
To configure port mirroring, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to
switch » port-mirroring .
3. Configure port mirroring for a specific port by typing:
switch
port-mirroring enabled target-slot slot target-port port egress-src egress ingress-src
ingress
Where:
•
slot
is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk)
•
egress
is the port number for the outgoing port
• ingress is the port number for the the incoming port
4. Add egress and ingress source ports. For more information, refer to Section 16.1.2.2, “Adding an Egress
Source Port” and Section 16.1.3.2, “Adding an Ingress Source Port” .
5. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 16.1.2
Managing Egress Source Ports
This section describes how to configure and manage egress source ports for port mirroring.
CONTENTS
• Section 16.1.2.1, “Viewing a List of Egress Source Ports”
• Section 16.1.2.2, “Adding an Egress Source Port”
• Section 16.1.2.3, “Deleting an Egress Source Port”
Section 16.1.2.1
Viewing a List of Egress Source Ports
To view a list of egress source port for port mirroring, type:
show running-config switch port-mirroring egress-src
If egress source ports have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config switch port-mirroring egress-src
switch port-mirroring
egress-src lm1 1
!