Siemens RUGGEDCOM ROX II, User Manual

Page: 345 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 8
Layer 2
Managing Egress Ports for Multicast Groups 299
Section 8.4.5
Managing Egress Ports for Multicast Groups
This section describes how to configure and manage egress ports for a multicast group.
CONTENTS
• Section 8.4.5.1, “Viewing a List of Egress Ports”
• Section 8.4.5.2, “Adding an Egress Port”
• Section 8.4.5.3, “Deleting an Egress Port”
Section 8.4.5.1
Viewing a List of Egress Ports
To view a list of egress ports for a static multicast group defined in the Static Multicast Group Summary table,
type:
show
switch mcast-filtering static-mcast-table id address egress-ports
Where:
•
id is the ID for the VLAN upon which the static multicast group operates
•
address
is the MAC address for the device in the form of 01:xx:xx:xx:xx:xx
If egress ports have been established, a table or list similar to the following example appears:
ruggedcom# show running-config switch mcast-filtering static-mcast-table 10 01:00:00:01:01:01 egress-
ports
switch mcast-filtering
static-mcast-table 10 01:00:00:01:01:01
egress-ports lm2 1
!
!
!
If no egress ports have been configured, add egress ports as needed. For more information, refer to
Section 8.4.5.2, “Adding an Egress Port” .
Section 8.4.5.2
Adding an Egress Port
To add an egress port to a static multicast group defined in the Static Multicast Group Summary table, do the
following:
1. Make sure the CLI is in Configuration mode.
2. Add the egress port by typing:
switch mcast-filtering static-mcast-table id address egress-ports slot port
Where:
•
id
is the ID for the VLAN upon which the static multicast group operates
•
address
is the MAC address for the device in the form of 01:xx:xx:xx:xx:xx