Siemens RUGGEDCOM ROX II, User Manual

Page: 344 / 798

Chapter 8
Layer 2
RUGGEDCOM ROX II
CLI User Guide
298 Adding a Static Multicast Group Entry
If entries have been established, a table or list similar to the following example appears:
ruggedcom# show running-config switch mcast-filtering static-mcast-table
switch mcast-filtering
static-mcast-table 10 01:00:00:01:01:01
!
!
If no entries have been configured, add entries as needed. For more information, refer to Section 8.4.4.2, “Adding
a Static Multicast Group Entry” .
Section 8.4.4.2
Adding a Static Multicast Group Entry
To list a static multicast group from another device in the Static Multicast Summary table, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the table entry by typing:
NOTE
Letters in MAC addresses must be lowercase.
switch mcast-filtering static-mcast-table id address
Where:
•
id is the ID for the VLAN upon which the static multicast group operates
•
address
is the MAC address for the device in the form of 01:xx:xx:xx:xx:xx
3. Add one or more egress ports. For more information, refer to Section 8.4.5.2, “Adding an Egress Port” .
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 8.4.4.3
Deleting a Static Multicast Group Entry
To delete a static multicast group from the Static Multicast Summary table, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the table entry by typing:
no switch mcast-filtering static-mcast-table id address
Where:
•
id
is the ID for the VLAN upon which the static multicast group operates
•
address
is the MAC address for the device in the form of 01:xx:xx:xx:xx:xx
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.