RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Configuring the Distribution of Prefix Lists
495
3. [Optional] Enable the neighbor as a route reflector client by configuring the following parameter:
Parameter
Description
enabled
If enabled and Route Reflector enabled, makes this neighbor a client for Route Reflector.
4. [Optional] Configure the route map settings by configuring the following parameter(s):
Parameter
Description
in { in }
Synopsis:
A string
Apply route map to incoming routes.
out { out }
Synopsis:
A string
Apply route map to outbound routes.
5. [Optional] Configure the neighbor settings by configuring the following parameter(s):
Parameter
Description
remote-as { remote-as }
Synopsis:
A 32-bit unsigned integer between 1 and 65535
A BGP neighbor.
This parameter is mandatory.
ebgp-multihop { ebgp-multihop }
Synopsis:
An 8-bit unsigned integer between 1 and 255
The maximum hop count. This allows EBGP neighbors not on directly connected
networks.
maximum-prefix { maximum-prefix }
Synopsis:
A 32-bit unsigned integer between 1 and 4294967295
The maximum prefix number accepted from this peer.
next-hop-self
Disables the next hop calculation for this neighbor.
password { password }
Synopsis:
A string 1 to 1024 characters long
Password.
update-source { update-source }
Synopsis:
A string 7 to 15 characters long
Source IP address of routing updates.
disable-connected-check
Disables connection verification when establishing an eBGP peering session with a
single-hop peer that uses a loopback interface.
soft-reconfiguration
Per neighbor soft reconfiguration.
weight { weight }
Synopsis:
A 16-bit unsigned integer
The default weight for routes from this neighbor.
6. Type
commit
and press
Enter
to save the changes, or type
revert
and press
Enter
to abort.
Section 13.8.6.3
Configuring the Distribution of Prefix Lists
To configure the distribution of prefix lists for a neighbor in a BGP network, do the following:
1. Make sure the CLI is in Configuration mode.
2. Apply the desired prefix list the chosen route direction (incoming or outbound) by typing:
routing
bgp neighbor
address
distribute-prefix-list [ in | out ] prefix-list
prefix
Summary of Contents for RUGGEDCOM ROX II
