Siemens RUGGEDCOM ROX II, User Manual

Page: 643 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Viewing a List of Static RP Addresses 597
and/or the RP assignment does not change often. It is important though that all static RP addresses be mirrored on
all PIM-SM enabled devices in the multicast domain.
CONTENTS
• Section 13.14.8.1, “Viewing a List of Static RP Addresses ”
• Section 13.14.8.2, “Adding a Static RP Address”
• Section 13.14.8.3, “Deleting a Static RP Address”
Section 13.14.8.1
Viewing a List of Static RP Addresses
To view a list of static RP addresses, type:
show running-config routing multicast dynamic pim-sm rp-address
If addresses have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing multicast dynamic pim-sm rp-address | tab
ADDRESS GROUP PRIORITY
---------------------------------------
172.30.145.254 225.0.2.6/8 -
192.168.0.10 225.0.0.1/8 -
!
If no addresses have been configured, add addresses as needed. For more information, refer to Section 13.14.8.2,
“Adding a Static RP Address” .
Section 13.14.8.2
Adding a Static RP Address
To add a static RP address, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the RP address by typing:
routing
multicast dynamic pim-sm rp-address static-address group-address priority priority
Where:
•
static-address
is the IP address of the RP
•
group-address
is the multicast address of the group handled by the RP
•
priority
is the the RP's priority in the election process
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 13.14.8.3
Deleting a Static RP Address
To delete a static RP address, do the following:
1. Make sure the CLI is in Configuration mode.