Chapter 13
Unicast and Multicast Routing
RUGGEDCOM ROX II
CLI User Guide
574
Configuring the Distribution of Prefix Lists
Parameter
Description
send-community { send-community }
Synopsis:
{ standard, extended, both, none }
Default:
both
Identifies the send Community. Default is both.
remote-as { remote-as }
Synopsis:
A 32-bit unsigned integer between 1 and 65535
A BGP neighbor.
This parameter is mandatory.
ebgp-multihop { ebgp-multihop }
Synopsis:
An 8-bit unsigned integer between 1 and 255
The maximum hop count. This allows EBGP neighbors not on directly connected
networks.
maximum-prefix { maximum-prefix }
Synopsis:
A 32-bit unsigned integer between 1 and 4294967295
The maximum prefix number accepted from this peer.
next-hop-self
Disables the next hop calculation for this neighbor.
password { password }
Synopsis:
A string 1 to 1024 characters long
Password.
update-source { update-source }
Synopsis:
A string 7 to 15 characters long
Source IP address of routing updates.
disable-connected-check
Disables connection verification when establishing an eBGP peering session with a
single-hop peer that uses a loopback interface.
soft-reconfiguration
Per neighbor soft reconfiguration.
weight { weight }
Synopsis:
A 16-bit unsigned integer
The default weight for routes from this neighbor.
4. Configure the route map settings by configuring the following parameter(s):
Parameter
Description
in { in }
Synopsis:
A string
Apply route map to incoming routes.
out { out }
Synopsis:
A string
Apply route map to outbound routes.
5. Configure the prefix list distribution. For more information, refer to
Section 13.11.12.3, “Configuring the
.
6. Type
commit
and press
Enter
to save the changes, or type
revert
and press
Enter
to abort.
Section 13.11.12.3
Configuring the Distribution of Prefix Lists
To configure the distribution of prefix lists for a neighbor in an IPv4 address family, do the following:
1. Make sure the CLI is in Configuration mode.
2. Apply the desired prefix list the chosen route direction (incoming or outbound) by typing:
routing
bgp address-family ipv4 vrf
vrf
neighbor
address
distribute-prefix-list [ in | out ]
prefix-list
prefix
Summary of Contents for RUGGEDCOM ROX II
