Siemens RUGGEDCOM ROX II, User Manual

Page: 527 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Managing Route Maps 481
Parameter Description
router-id { router-id } Synopsis: A string 7 to 15 characters long
Router ID for BGP.
3. Configure autonomous system path filters. For more information, refer to Section 13.8.5.3, “Adding an
Autonomous System Path Filter” .
4. Configure prefix list filters. For more information, refer to Section 13.8.4.3, “Adding a Prefix List” .
5. Configure route map filters. For more information, refer to Section 13.8.2.3, “Adding a Route Map Filter” .
6. Configure a network. For more information, refer to Section 13.8.7.2, “Adding a Network” .
7. Configure IP addresses for neighbors. For more information, refer to Section 13.8.6.2, “Adding a Neighbor” .
8. Configure aggregate addresses. For more information, refer to Section 13.8.8.2, “Adding an Aggregate
Address” .
9. Configure redistribution metrics. For more information, refer to Section 13.8.10.2, “Adding a Redistribution
Metric” .
10. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
NOTE
Following a change in the routing policy due to a configuration change, the BGP session must be
reset for the new policy to take effect.
11. Reset the BGP session. For more information, refer to Section 13.8.13, “Resetting a BGP Session” .
Section 13.8.2
Managing Route Maps
Route maps are sequential statements used to filter routes that meet the defined criteria. If a route meets the
criteria of the applied route map, it can either be excluded from the routing table or prevented from being
redistributed.
Each route map requires a sequence number (e.g. 10, 20, 30, etc.), which allows for multiple route maps to be
run in sequence until a match is found. It is recommended to create sequence numbers in intervals of 10, in case a
new route map is required later between two existing route maps.
CONTENTS
• Section 13.8.2.1, “Viewing a List of Route Map Filters”
• Section 13.8.2.2, “Viewing a List of Route Map Filter Entries”
• Section 13.8.2.3, “Adding a Route Map Filter”
• Section 13.8.2.4, “Adding a Route Map Filter Entry”
• Section 13.8.2.5, “Deleting a Route Map Filter”
• Section 13.8.2.6, “Deleting a Route Map Filter Entry”
• Section 13.8.2.7, “Configuring Match Rules”
• Section 13.8.2.8, “Configuring a Set”