Siemens RUGGEDCOM ROX II, User Manual

Page: 289 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 7
IP Address Assignment
Adding a Host 243
• For IPv6
show running-config services dhcpserver6 host
If hosts have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config services dhcpserver host APE-INT
services
dhcpserver
host APE-INT
options
hardware mac 00:01:C0:0B:B7:71
fixed-ip 192.168.0.60
unknown-client allow
subnet SUB2
client
hostname APE-INT
no subnetmask
no default-route
no broadcast
no domain
no dns-server
no static-route
no nis server
no nis domain
!
!
!
!
!
If no hosts have been configured, add hosts as needed. For more information, refer to Section 7.3.10.2, “Adding a
Host” .
Section 7.3.10.2
Adding a Host
To add a host to the DHCP server, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the host by typing:
• For IPv4
services dhcpserver host
name
• For IPv6
services
dhcpserver6 host name
Where:
•
name is the name of the host
3. Configure options for the host. For more information, refer to Section 7.3.10.3, “Configuring Host Options” .
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 7.3.10.3
Configuring Host Options
To configure options for a host on the DHCP server, do the following: