Siemens RUGGEDCOM ROX II, User Manual

Page: 729 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 15
Network Discovery and Management
Deleting an SNMP Group 683
Section 15.2.9.3
Deleting an SNMP Group
To delete an SNMP group, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the SNMP group by typing:
no admin snmp snmp-access group model level
Where:
•
group
is the name of the group
•
model
is the security model for the group
•
level
is the security level for the group
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 15.3
Managing NETCONF
The Network Configuration Protocol (NETCONF) is a network configuration protocol developed by the Internet
Engineering Task Force (IETF). NETCONF provides functions to download, upload, change, and delete the
configuration data on network devices. RUGGEDCOM ROX II devices also support the ability to collect data and
perform direct actions on the device, such as rebooting the device, clearing statistics, and restarting services.
NOTE
For more information about NETCONF and its use, refer to the NETCONF Reference Guide for
RUGGEDCOM ROX II v2.12.
CONTENTS
• Section 15.3.1, “Enabling and Configuring NETCONF Sessions”
• Section 15.3.2, “Viewing NETCONF Statistics”
Section 15.3.1
Enabling and Configuring NETCONF Sessions
To enable and configure NETCONF sessions, do the following:
1. Make sure the CLI is in Configuration mode.
CAUTION!
Security hazard – risk of unauthorized access/exploitation. Configure an idle timeout period for
NETCONF to prevent unauthorized access (e.g. a user leaves their station unprotected) or denial
of access (e.g. a guest user blocks an admin user by opening the maximum number of NETCONF
sessions).