Chapter 12
Tunneling and VPNs
RUGGEDCOM ROX II
CLI User Guide
414
Deleting a Connection
1. Make sure the CLI is in Configuration mode.
2. Enable dead peer detection by typing:
tunnel
ipsec connection
name
dead-peer-detect enabled [ true | false ]
Where:
•
name
is the connection name.
3. Configure the following parameter(s) as required:
NOTE
The timeout period must be two minutes longer than the interval period.
Parameter
Description
interval { interval }
Synopsis:
A 32-bit unsigned integer between 1 and 3600
Default:
30
The interval (in seconds) between Dead Peer Detection keepalive messages sent for this
connection when no traffic (idle) appears to be sent by a DPD enabled peer.
timeout { timeout }
Synopsis:
A 32-bit unsigned integer between 1 and 28800
Default:
120
The time in seconds to wait before a peer is declared dead.
action { action }
Synopsis:
{ hold, clear, restart, restart-all-sa }
Default:
restart
The action to be taken when a DPD enabled peer is declared dead. Options include:
• hold: The route will be put on hold status.
• clear: The route and Security Association (SA) will both be cleared
• restart: The SA will immediately be renegotiated
• restart-all-sa: All SA's to the dead peer will be renegotiated
4. Type
commit
and press
Enter
to save the changes, or type
revert
and press
Enter
to abort.
Section 12.8.6.4
Deleting a Connection
To delete a connection for a VPN, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the connection by typing:
no
tunnel ipsec connection
name
Where:
•
name
is the name of the connection
3. Type
commit
and press
Enter
to save the changes, or type
revert
and press
Enter
to abort.
Section 12.8.6.5
Viewing the Status of a Connection
To view the status of an IPsec connection, type:
Summary of Contents for RUGGEDCOM ROX II
