Siemens RUGGEDCOM ROX II, User Manual

Page: 333 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 8
Layer 2
Viewing a List of Static MAC Addresses 287
Prioritized MAC addresses are configured when traffic to or from a specific device on a LAN segment is to be
assigned a higher CoS priority than other devices on that LAN segment.
CONTENTS
• Section 8.3.4.1, “Viewing a List of Static MAC Addresses”
• Section 8.3.4.2, “Adding a Static MAC Address”
• Section 8.3.4.3, “Deleting a Static MAC Address”
Section 8.3.4.1
Viewing a List of Static MAC Addresses
To view a list of static MAC addresses configured on the device, type:
show running-config switch mac-tables static-mac-table
If static MAC addresses have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config switch mac-tables static-mac-table | tab
MAC VID LEARNED SLOT PORT COS
------------------------------------------------------
00:0a:dc:f6:8b:ff 4085 - lm1 2 normal
00:10:94:00:24:01 4084 - lm1 1 normal
00:10:94:00:30:01 1 - lm1 2 normal
00:10:94:00:40:01 4086 - lm1 2 normal
!
If no static MAC addresses have been configured, add addreses as needed. For more information, refer to
Section 8.3.4.2, “Adding a Static MAC Address” .
Section 8.3.4.2
Adding a Static MAC Address
To add a static MAC address, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the static MAC address by typing:
NOTE
Letters in MAC addresses must be lowercase.
switch
mac-tables static-mac-table static-mac address vlan
Where:
•
address is the Unicast MAC address that is to be statically configured. It can have up to 6 '*' wildcard
characters continuously applied from the right.
•
vlan
is the ID of the VLAN upon which the MAC address operates.
3. Configure the following parameter(s) as required: