Siemens RUGGEDCOM ROX II, User Manual

Page: 125 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 4
Device Management
Deleting a Remote Server 79
Section 4.10.5.3
Deleting a Remote Server
To delete a remote server, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the remote server by typing:
no admin logging server address
Where:
•
address
is the IP address of the remote server.
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 4.10.6
Managing Remote Server Selectors
Remote server selectors filter the information sent to specific servers.
CONTENTS
• Section 4.10.6.1, “Viewing a List of Remote Server Selectors”
• Section 4.10.6.2, “Adding a Remote Server Selector”
• Section 4.10.6.3, “Deleting a Remote Server Selector”
Section 4.10.6.1
Viewing a List of Remote Server Selectors
To view a list of remote server selectors, type:
show running-config admin logging server address selector
Where:
•
address
is the IP address of the remote server.
If remote server selectors have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config admin logging server 172.30.144.254 selector
admin
logging
server 172.30.144.254
selector 1
no negate
facility-list [ all ]
!
!
!
!
If no remote server selectors have been configured, add selectors as needed. For more information, refer to
Section 4.10.6.2, “Adding a Remote Server Selector” .