Siemens RUGGEDCOM ROX II, User Manual

Page: 395 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 10
Serial Server
Deleting a Remote Host 349
Section 10.5.3
Deleting a Remote Host
To delete a remote host, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the remote host by typing:
no interface serial
slot port
protocols rawsocket setrawsocket remote-host
address remote-port
Where:
•
slot
is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
•
address
is the IP address for the remote host
• remote-port is the port number for the remote host
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 10.6
Managing Local Hosts
Local hosts are required when the UDP transport connection protocol is selected and multicast streams are to be
received for the raw socket protocol.
CONTENTS
• Section 10.6.1, “Viewing a List of Local Hosts”
• Section 10.6.2, “Adding a Local Host”
• Section 10.6.3, “Deleting a Local Host”
Section 10.6.1
Viewing a List of Local Hosts
To view a list of local hosts configured for a serial port using the raw socket protocol, type:
show running-config interface serial protocols rawsocket setrawsocket local-host
If hosts have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config interface serial protocols rawsocket setrawsocket local-host
interface
serial lm5 1
protocols rawsocket
setrawsocket local-host 224.1.2.1
interface ge-4-4
!
!
!
!
!