Siemens RUGGEDCOM ROX II, User Manual

Page: 722 / 798

Chapter 15
Network Discovery and Management
RUGGEDCOM ROX II
CLI User Guide
676 Managing SNMP Target Addresses
•
name
is the name of the community
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 15.2.6
Managing SNMP Target Addresses
This section describes how to manage SNMP target addresses.
CONTENTS
• Section 15.2.6.1, “Viewing a List of SNMP Target Addresses”
• Section 15.2.6.2, “Adding an SNMP Target Address”
• Section 15.2.6.3, “Deleting an SNMP Target Address”
Section 15.2.6.1
Viewing a List of SNMP Target Addresses
To view a list of SNMP target addresses configured on the device, type:
show running-config admin snmp snmp-target-address
If target addresses have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config admin snmp snmp-target-address | tab
TARGET TRAP SECURITY USER SECURITY
TARGET NAME ENABLED ADDRESS PORT MODEL NAME LEVEL
--------------------------------------------------------------------------------
127.0.0.1 v1 true 127.0.0.1 162 v1 oper noAuthNoPriv
127.0.0.1 v2 true 127.0.0.1 162 v2c oper noAuthNoPriv
127.0.0.1 v3.guest true 127.0.0.1 162 v3 admin noAuthNoPriv
127.0.0.1 v3.inform true 127.0.0.1 162 v3 admin authPriv
127.0.0.1 v3.trap true 127.0.0.1 162 v3 admin authNoPriv
target true 192.168.0.111 162 v2c admin noAuthNoPriv
!
!
If no SNMP target addresses have been configured, add target addresses as needed. For more information, refer to
Section 15.2.6.2, “Adding an SNMP Target Address” .
Section 15.2.6.2
Adding an SNMP Target Address
To add an SNMP target address, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to
admin » snmp » snmp-target-address and configure the following parameter(s) as required:
Parameter Description
{ target-name } Synopsis: A string 1 to 32 characters long