Siemens RUGGEDCOM ROX II, User Manual

Page: 279 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 7
IP Address Assignment
Viewing a List of Shared Networks 233
multiple virtual networks exist on one physical interface. Each subnet then gets its own subnet definition inside
the shared network rather than at the top level. Shared networks contain subnets, groups and hosts.
CONTENTS
• Section 7.3.7.1, “Viewing a List of Shared Networks”
• Section 7.3.7.2, “Adding a Shared Network”
• Section 7.3.7.3, “Configuring Shared Network Options”
• Section 7.3.7.4, “Deleting a Shared Network”
Section 7.3.7.1
Viewing a List of Shared Networks
To view a list of shared networks, type:
•
For IPv4
show
running-config services dhcpserver shared-network
• For IPv6
show running-config services dhcpserver6 shared-network
If shared networks have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config services dhcpserver shared-network
services
dhcpserver
shared-network Shared
options client
no hostname
no subnetmask
no default-route
no broadcast
no domain
no dns-server
no static-route
no nis server
no nis domain
!
!
!
!
If no shared networks have been configured, add shared networks as needed. For more information, refer to
Section 7.3.7.2, “Adding a Shared Network” .
Section 7.3.7.2
Adding a Shared Network
To add a shared network to the DHCP server, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the shared network by typing:
• For IPv4
services
dhcpserver shared-network name