Siemens RUGGEDCOM ROX II, User Manual

Page: 531 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Configuring a Set 485
Section 13.8.2.8
Configuring a Set
To configure matched rules for a route map filter entry, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to
routing » bgp » filter » route-map » {tag} » entry » {number} » set , where {tag} is the tag for
the route map filter and {number} is the sequence number for the entry.
3. Configure the following parameters as required:
Parameter Description
local-preference { local-preference } Synopsis: A 32-bit unsigned integer
Local preference.
next-hop { next-hop } Synopsis: { peer } or a string 7 to 15 characters long
The next hop address (xxx.xxx.xxx.xxx/xx or peer to use peer address).
origin { origin } Synopsis: { egp, igp, incomplete }
The origin code.
originator-id { originator-id } Synopsis: A string 7 to 15 characters long
This parameter is not supported and any value is ignored by the system.
weight { weight } Synopsis: A 32-bit unsigned integer
Weight.
4. Add pre-pended and/or excluded autonomous system paths. For more information, refer to Section 13.8.3.3,
“Adding a Prepended Autonomous System Path Filter” and/or Section 13.8.3.4, “Adding an Excluded
Autonomous System Path filter” .
5. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 13.8.3
Managing Prepended and Excluded Autonomous System Path
Filters
This section describes how to configure and manage prepended and excluded autonomous system path filters.
CONTENTS
• Section 13.8.3.1, “Viewing a List of Prepended Autonomous System Path Filters”
• Section 13.8.3.2, “Viewing a List of Excluded Autonomous System Paths”
• Section 13.8.3.3, “Adding a Prepended Autonomous System Path Filter”
• Section 13.8.3.4, “Adding an Excluded Autonomous System Path filter”
• Section 13.8.3.5, “Deleting a Prepended Autonomous System Path Filter”
• Section 13.8.3.6, “Deleting an Excluded Autonomous System Path Filter”