Siemens RUGGEDCOM ROX II, User Manual

Page: 357 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 8
Layer 2
Managing Static VLANs 311
1. Make sure the CLI is in Configuration mode.
2. Navigate to
switch » vlans » all-vlans » {id} , where {id} is the ID of the VLAN and configure the following
parameter(s) as needed:
Parameter Description
{ vid } Synopsis: A 32-bit signed integer between 1 and 4094
The VLAN ID for this routable logical interface.
ip-address-src { ip-address-src } Synopsis: { static, dynamic }
Whether the IP address is static or dynamically assigned via Dynamic Host Configuration
Protocol (DHCP) or Bootstrap Protocol (BOOTP). The DYNAMIC option is a common
case of a dynamically assigned IP address. It switches between BOOTP and DHCP until
it gets the response from the relevant server. This must be static for non-management
interfaces.
This parameter is mandatory.
ipv6-address-src { ipv6-address-src } Synopsis: { static, dynamic }
Default: static
Whether the IPv6 address is static or dynamically assigned via Dynamic Host
Configuration Protocol (DHCP). This must be static for non-management interfaces.
proxyarp Enables/Disables whether the VLAN will respond to ARP requests for hosts other than
itself.
on-demand Brings up this interface on demand only.
mtu { mtu } Synopsis: A 32-bit signed integer between 68 and 9216
Default: 1500
The maximum transmission unit (the largest packet size allowed for this interface).
3. Add Quality of Service (QoS) maps to the VLAN. For more information, refer to Section 16.2.7.2, “Adding a
QoS Map” .
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 8.5.5
Managing Static VLANs
This section describes how to configure and manage static VLANs.
CONTENTS
• Section 8.5.5.1, “Viewing a List of Static VLANs”
• Section 8.5.5.2, “Adding a Static VLAN”
• Section 8.5.5.3, “Deleting a Static VLAN”
Section 8.5.5.1
Viewing a List of Static VLANs
To view a list of static VLANs, type:
show running-config switch vlans static-vlan