Siemens RUGGEDCOM ROX II, User Manual

Page: 518 / 798

Chapter 13
Unicast and Multicast Routing
RUGGEDCOM ROX II
CLI User Guide
472 Managing the Prefix List Distribution
no routing rip network neighbor address
Where:
•
address
is the IP address of the neighbor
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 13.7.8
Managing the Prefix List Distribution
This section describes how to manage the distribution of prefix lists.
CONTENTS
• Section 13.7.8.1, “Viewing a List of Prefix List Distribution Paths”
• Section 13.7.8.2, “Adding a Prefix List Distribution Path”
• Section 13.7.8.3, “Deleting a Prefix List Distribution Path”
Section 13.7.8.1
Viewing a List of Prefix List Distribution Paths
To view a list of prefix list distribution paths for dynamic RIP routes, type:
show running-config routing rip distribute-prefix-list
If distribution paths have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing rip distribute-prefix-list
routing rip
distribute-prefix-list out ""
prefix-list list-permit-lan-22
!
!
If no prefix list distribution paths have been configured, add distribution paths as needed. For more information,
refer to Section 13.7.8.2, “Adding a Prefix List Distribution Path” .
Section 13.7.8.2
Adding a Prefix List Distribution Path
To add a prefix list distribution path for dynamic RIP routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the path by typing:
routing rip distribute-prefix-list direction interface
Where:
•
direction
is the direction (incoming or outgoing) in which to filter routing updates.
•
interface
is the name of the interface. This parameter is optional.