Siemens RUGGEDCOM ROX II, User Manual

Page: 407 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 12
Tunneling and VPNs
Adding a Virtual Switch Interface 361
!
!
If no virtual switch interfaces have been configured, add interfaces as needed. For more information, refer to
Section 12.1.4.2, “Adding a Virtual Switch Interface” .
Section 12.1.4.2
Adding a Virtual Switch Interface
To add a virtual switch interface, do the following:
IMPORTANT!
At least two interfaces are required for a virtual switch bridge.
CAUTION!
Accessibility hazard – risk of access disruption. Do not select the interface used to the access the Web
interface. Active Web sessions will be lost and the Web interface will be unreachable until the virtual
switch is disabled.
NOTE
The wlan-cl1 interface is not supported as a virtual switch interface.
1. Make sure the CLI is in Configuration mode.
2. Add an interface to the virtual switch by typing:
interface virtualswitch name interface interface
Where:
•
name
is the name assigned to the virtual switch
•
interface
is the name assigned to the interface
The new interface is now accessible by typing:
ip
vsw- name
The new virtual switch is now visible under the ip menu with the prefix vsw- (i.e. vsw-vs1, vsw-vs2, etc.).
3. Assign an IPv4 or IPv6 address to the interface. For more information, refer to Section 7.1.3.2, “Adding an
IPv4 Address” or Section 7.1.4.2, “Adding an IPv6 Address” .
4. If necessary, add one or more VLANs to the virtual switch interface. For more information, refer to
Section 12.1.8.2, “Adding a Virtual Switch VLAN” .
5. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 12.1.4.3
Deleting a Virtual Switch Interface
To delete a virtual switch interface, do the following:
1. Make sure the CLI is in Configuration mode.