
SG-2000 MANUAL
75
The SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA
©1995, SGC, Inc.
TEL: (206) 746-6310 FAX: (206) 746-6384
Program a Channel Bank
The SG-2000 has six channel banks numbered 00 to 05. Each of these
banks will hold up to 10 channels, complete with mode and offset (if
duplex). The entry sequence is:
1)
Press the “PRGM” button.
2)
Press the “SCAN” button.
Note: The display will show the “PRGM” indicator active with the large digit
display showing a “-0” on the far left.
3)
Enter the desired bank number to be programmed (0-5). The
display will show the bank number on the far left of the display
and the previous channel programmed in the first file of that bank.
If the file has not been previously programmed, the display will
show four dashes to indicate it is empty.
4)
If the file is empty, as indicated by four dashes, enter the desired
channel number.
5)
Press the “Up” arrow to proceed to next file in that bank and repeat
step 4, or press the “PRGM” key to end the function.
6)
If a file is not empty, the file can be deleted by first engaging
“SHIFT/FUNC” and then “7” or “INTCM/XCV.”
7)
Press the “PRGM” button to end the function.
Scan by Frequency - General
1)
Press the “SCAN” button.
2)
Press the “FREQ” button.
Note: If there are no buttons pressed within 4 seconds, the unit will start scan-
ning automatically from the original channel on display at the start of the
function.
3)
To change the direction of the scan or to step through the
frequencies, press the respective “Up” or “Down” arrow.
4)
To allow the pause on detection, press the squelch by pressing “3”
or “SQL.”
5)
To stop the scan, simply press the “SCAN” button.