
SG-2000 MANUAL
32
The SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA
©1995, SGC, Inc.
TEL: (206) 746-6310 FAX: (206) 746-6384
19.
Re-install control head cable connector (10-position) into rear
panel (from step #5)
20.
Re-install cable clamp using one #4 Philips Head screws
(from step #4).
21.
Re-install rear panel connector cover using three #4 Philips
Head screws (from step #3).
22.
Install louvered top cover (supplied) using six #6 black
Philips Head screws (from step 2).
This concludes the Rack Mount Retrofit Procedure.
9.5
Control Head Installations
The SG-2000 is a multiple control head radio. There are two ways to obtain a remote
head configuration. First is to remove the control head supplied on the SG-2000.
Second is to plug in additional control heads. While most people order their SG-2000
with the Remote Head Kit installed, this item may be installed in the field through the
following procedure:
9.6
Remote Head Kit Installation (Part No. 04-12)
As supplied, the SG-2000 comes with a control panel attached to the front of the radio.
As an option, a remote head kit, part number 04-12 may be installed, extending the
control head 16 feet from the radio and supplying a gimbal mount. Installation takes 10
minutes.
TOOLS REQUIRED:
Philips Head Screwdriver
TEST EQUIPMENT REQUIRED:
None
CAUTIONS:
•
Power must be disconnected from radio for this
procedure.
•
Use care not to over tighten screws and strip threads.
I
nstallation Procedure
1.
Locate and remove the wiring shield on the back of the SG-2000. This
shield, which runs horizontally across the back of the radio, is held in
place by three Phillips head screws. Unplug the control head number
1 cable.
2.
Locate and remove the six black Phillips head screws which secure the
top cover to the SG-2000 and remove the top cover. Two screws are
located on each side of the radio and two screws are located on the top