
SG-2000 MANUAL
29
The SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA
©1995, SGC, Inc.
TEL: (206) 746-6310 FAX: (206) 746-6384
TEST EQUIPMENT REQUIRED:
None
CAUTIONS:
•
Power must be disconnected from radio.
•
Do not over tighten screws which will strip heads.
Installation Procedure
1.
Remove top cover-secured by six black #6 Philips Head
screws-set cover and screws aside.
2.
Remove bottom cover-secured by six black #6 Philips Head
screws-set cover and screws aside.
3.
Remove rear panel connector cover-secured by three #4
Philips Head screws-set cover and screws aside.
4.
Remove rear panel control head cable clamp-secured by one
#4 Philips Head screw-set screw and clamp aside.
5.
Unplug control head cable connector (10-position) from rear
panel.
6.
Remove control head as follows:
a.
Remove two #6 Philips Flathead screws from either side
panel (located towards front of radio)
b.
Remove two #6 Philips Flathead screws from other side
panel (located towards front of radio)
c.
Lift control head cable up and out of cable U-Channel.
d.
Gently pull control head/cable assembly forward-set this
assembly aside.
7.
Install the fan option connector assembly supplied by
plugging the connector into J16 with the Green wire to Pin 1.
8.
Set the radio (upside up) into the tray assembly. Rear of
radio should face power cables.
9.
Lift the rear of the radio (if necessary) and install the DC
power wires to the radio DC terminal strip; red to "+", black
to "-" set radio back down (if necessary).
10.
Secure radio to bottom cover. Use four #6 black Philips
Head screws removed in step #2.