
SG-2000 MANUAL
30
The SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA
©1995, SGC, Inc.
TEL: (206) 746-6310 FAX: (206) 746-6384
11.
Install RF ground jumper braid onto radio rear panel RF
ground bolt.
12.
Install RF coax jumper into radio rear panel RF in/out
connector-set the radio/tray assembly aside.
13.
Install the control head rear panel as follows;
a.
Unplug the control head cable connector (10-position) from
the control head display board assembly-set the cable
assembly aside.
b.
Remove either head mounting bracket by removing two
Philips Head screws.
c.
Remove other head mounting bracket by removing two
Philips Head screws.
d.
Install the four longer threaded stand-offs, SGC part # 965-
913 (supplied), into the inserts from which the screws were
removed in steps B and C above.
e.
Replace four #4 Philips Head microprocessor assembly
mounting screws with the four shorter threaded stand-offs,
SGC part #965-908 (supplied).
f.
Remove control head connector (10-position) from control
head cable.
g.
Pass the control head cable through the Heyco watertight
fitting on the control head rear panel (supplied). Do not
tighten the Heyco.
h.
Re-install connector removed in Step F (see illustration
supplied).
i.
Install control head connector onto control head display
board assembly (from step A)
j.
Attach control head rear panel to control head using eight #4
Philips Flathead screws (supplied).
k.
Tighten Heyco
17.
Attach control head assembly to rack mount front panel
using four each #8 nuts (supplied attached to control head
rear panel).
18.
Attach control head/front panel assembly to tray assembly
using 7 each #4 lock washers and #4 nuts (supplied attached