Ruijie Networks RG-S2600E Series, Cli Reference Manual

Page: 99 / 1191

S2600E/P CLI Reference Guide Chapter 1 Interface Configuration Commands
Parameter Description
allowed vlan
vlan-list
Configure the list of VLANs allowed on
the trunk port.
vlan-list
can be a VLAN
or a range of VLANs starting with the
smaller VLAN ID and ending with the
larger VLAN ID and being separated by
hyphen, for example, 10 to 20. The
segments can be separated with a
comma (,), for example, 1 to 10, 20 to
25, 30, 33.
all means that the allowed VLAN list
contains all the supported VLANs;
add means to add the specified VLAN
list to the allowed VLAN list;
remove means to remove the specified
VLAN list from the allowed VLAN list;
except means to add all the VLANs
other than those in the specified VLAN
list to the allowed VLAN list;
Parameter
description
native vlan
vlan-id
Specify the native VLAN.
Default
configuration
The allowed VLAN list is all, the Native VLAN is VLAN1.
Command
mode
Interface configuration mode.
Usage
guidelines
Native VLAN
:
A trunk port belongs to one native VLAN. A native VLAN
means that the untagged packets received/sent on the
trunk port belong to the VLAN. Obviously, the default
VLAN ID of the interface (that is, the PVID in the IEEE
802.1Q) is the VLAN ID of the native VLAN. In addition,
when frames belonging to the native VLAN are sent over
the trunk port, they are untagged.
Allowed-VLAN List:
By default, a trunk port sends traffic to and received traffic
from all VLANs (ID 1 to 4094). However, you can prevent
the traffic from passing over the trunk by configuring
allowed VLAN lists on a trunk.
Use
show interfaces switchport
to display configuration.