Ruijie Networks RG-S2600E Series, Cli Reference Manual

Page: 271 / 1191

S2600E/P CLI Reference Guide Chapter 3 IPv6 Configuration Commands
Use show ipv6 neighbors to view the neighbor
information.
Examples
Ruijie(config)# ipv6 neighbor 2001::1 vlan 1
00d0.f811.1111
Command Description
show ipv6
neighbors
Show the neighbor information.
Related
commands
clear ipv6
neighbors
Clear the neighbors learned
dynamically.
3.1.7 ipv6 nd dad attempts
Use this command to set the number of the NS packets to be continuously sent
for IPv6 address collision check on the interface. Use the no form of this
command to restore it to the default setting.
ipv6 nd dad attempts value
no ipv6 nd dad attempts
Parameter Description
Parameter
description
value
Number of the NS packets. If it is set to
0, it indicates that the IPv6 address
collision check is disabled on the
interface. The range is 0 to 600.
Default
configuration 1.
Command
mode Interface configuration mode.
Usage
guidelines
When the interface is configured with a new IPv6 address,
the address collision shall be checked before the address
is assigned to the interface, and the address shall be in
the ”tentative” status. After the address collision check is
completed, if no collision is detected, the address can be
used normally; if collision is detected and the interface ID
of the address is an EUI-64 ID, it indicates that the
link-layer address is repeated, and the system will
automatically shut down the interface (that is, to prohibit