Ruijie Networks RG-S2600E Series, Cli Reference Manual

Page: 88 / 1191

S2600E/P CLI Reference Guide Chapter 1 Interface Configuration Commands
flowcontrol
{
auto | off | on | receive {auto | off | on } | send {auto | off | on}
}
no flowcontrol
Parameter Description
auto
Self-negotiate the flow control.
off
Disable the flow control.
on
Enable the flow control.
receive
Receiving direction of the
non-symmetric flow control.
Parameter
description
send
Sending direction of the non-symmetric
flow control.
Default
configuration
By default, flow control is enabled on the S26 and S26E
device, while disabled on other devices.
Command
mode
Interface configuration mode.
Usage
guidelines
Use
show interfaces
to display the flow control
configurations.
Examples
This example shows how to enable flow control on
fastEthernet port 1/1:
Ruijie(config)# interface gigabitethernet 1/1
Ruijie(config-if)# flowcontrol on
Command Description
Related
commands
show
interfaces
Show the interface information.
1.1.7 interface aggregateport
Use this command to access or create an aggregate port and enter interface
configuration mode. Use the
no
form of the command to remove this port.
interface aggregateport port-number
Parameter Description
Parameter
description
port-number
Aggregate port number. Its range
depends on the equipment and
extended modules.