Ruijie Networks RG-S2600E Series, Cli Reference Manual

Page: 276 / 1191

S2600E/P CLI Reference Guide Chapter 3 IPv6 Configuration Commands
prefix default ; only the prefix that uses all the default
configurations can be modified with this command.
at valid-date preferred-date
The valid lifetime of a prefix can be specified in two ways.
One way is to specify a fixed time for each prefix in the RA;
the other way is to specify the end time (in this mode, the
valid lifetime of the prefix sent in RA will be gradually
reduced until the end time is 0).
Examples
The following example adds a prefix for SVI 1.
Ruijie(config)# interface vlan 1
Ruijie(conifig-if)# ipv6 nd prefix 2001::/64
infinite
2592000
The following example sets the default prefix parameters
for SVI 1 (they cannot be used for auto address
configuration)
:
Ruijie(config)# interface vlan 1
Ruijie(config-if)# ipv6 prefix default
no-autoconfig
If no parameter is specified, the default parameters will be
used, and the prefix cannot be used for auto address
configuration.
Command Description
Related
commands
show ipv6
interface
Show the RA information of an
interface.
3.1.12 ipv6 nd ra-hoplimit
Use this command to set the hopcount of the RA message. Use the no form of
this command to restore it to the default setting.
ipv6 nd ra-hoplimit value
no ipv6 nd ra-hoplimit
Parameter Description
Parameter
description
value Hopcount
Default
configuration
The default value is 64.
Command
mode
Interface configuration mode.