CTS55 Module
Test
1094.0006.55 7.1
E-5
7
Module Test
7.1
Overview
Module test is an optional facility (option B7) for the CTS which provides a new test and an associated
second RF connector. If the option is available this will be indicated on the "Available Options" menu.
The main purpose of Module Test is to allow measurements to be made of a mobile’s transmitted
signal. This is done without the associated signalling normally needed to get a mobile into a state where
a call has been established. This usually needs the mobile to be in a special mode, details of which are
normally only available from the mobile manufacturer.
In Module Test there is also an RF generator available which transmits an RF signal. Many of the
characteristics of the signal are configurable by the user.
On the rear panel of the CTS there is an RF OUT connector (of type BNC). The output level at this
connector is approx. 35 dB higher than the RF IN/OUT connector on the front panel. This connector is
intended for use with the RF generator facility.
Summary of Contents for 1094.0006.50
