Rohde & Schwarz 1094.0006.50, Operating Manual

Page: 310 / 374

Windows

Application CTSgo CTS-K6
1079.2001.01 54 E-3
7.3.20 Remote Port
To ensure error-free functioning of the CTSgo software, the settings made for the remote control
interface (RS232) should match the settings on the CTS.
The parameters of the serial interface such as baud rate, data bits used, stop bits, parity used and the
protocol can be selected on the CTS. Adapt the settings of CTSgo to those of CTS by checking the
respective box. The serial interface of your PC and the command line terminator should also be set.
<CR>+<LF> should normally be used.
The timeout of the CTS for responding to a query should now be defined. This parameter depends on
the configuration of the individual tests. See also the note for the Test Parameters command.
Note:
In the case of a CTS30 the parameters of the serial interface are set as follows:
•
Baud rate 38400
•
8 data bits
•
1 stop bit
•
Parity None
•
Protocol CTS/RTS
Fig.: Remote port dialog window