Rohde & Schwarz 1094.0006.50, Operating Manual

Page: 36 / 374

Putting into Operation CTS55
1094.0006.55 2.4 E-11
2.2 Commissioning
2.2.1 Setting up the Instrument
For bench measurements, it is recommended that the fold out feet at the bottom of the instrument are
used as this improves the viewing angle of the screen.
For convenient operation of the instrument note the following:
•
Do not cover the ventilation openings!
•
Ambient tempe5 to +45 °C.
•
Avoid moisture and condensation, if it occurs however, the instrument must be thoroughly dried
before switching on.
2.2.2 Connecting the Instrument to the AC Supply
¾ Check the position of the voltage selector and set it to the local AC supply voltage if necessary.
¾ Plug the supplied power cable into the rear power connector and connect the CTS to the power
supply.
Instrument with input voltage selector
100 ... 120 V / 135 VA
200 ... 240 V / 160 VA
50 ... 60 Hz
Instrument with wide-range voltage input
100 ... 240 V / 160 VA
50 ... 60 Hz