Rohde & Schwarz 1094.0006.50, Operating Manual

Page: 57 / 374

CTS55 Test Sequence
1094.0006.55 4.5 E-6
Autotest Running Menu Autotest Running Menu
If the instrument has been configured for Dual Band handover, as in the above example, then a two
band autotest sequence will be attempted. This is depicted by the HO step in the signalling box.
A single band test will contain the NwRel as the final signalling step.
If a test cycle has already taken place, it is possible to start from the Autotest Result Menu using the
"Restart" key. The test sequence can be terminated at any time before it is completed by pressing the
"Stop" key in the Autotest Running Menu. The "Continue" key is used in step mode of the Autotest to
continue with the next step of the test sequence. The "Menu Up" hardkey returns to the previous menu
regardless of the state of the test. Any test results collected will be lost when the "Menu Up" key is
pressed.
Config - Select Menu Config Autotest Menu
To skip a test from being perfomed by Autotest Choose “Config – Select ”– “”Configure Autotest” and
set “No” to the tests in the “Config – Autotest” menu.