Rohde & Schwarz 1094.0006.50, Operating Manual

Page: 337 / 374

CTS-K6 Windows

Application CTSgo
1079.2001.01 81 E-3
7.7 Limits Menu in the DECT Autotest
With the items in the Limits menu, the upper and lower limits for the results are set. The settings made
here influence all subsequently generated measurement reports. Tolerances of already stored
measurement reports will not be influenced by these settings. Set limits are displayed in the second
and third column of the measurement report.
Note:
It is recommended to store the settings in the form of a configuration file.
7.7.1 NTP Measurements
This dialog window permits to define tolerances for Normal Transmit Power (NTP) measurements. The
NTP is the average power in the active part of the burst. Entered values are set by pressing OK. If
newly entered limit values should not be set, terminate the dialog with Cancel.
Set limits are indicated in the second and third column of the measurement report. Refer to the report
section shown below.
Fig.: Limits menu in the DECT
autotest
Fig.: NTP Measurement dialog window
Fig.: Extract from the NTP measurement report