Rohde & Schwarz 1094.0006.50, Operating Manual

Page: 119 / 374

CTS55 Description of the Menus
1094.0006.55 9.11 E-7
9.5.6 Autotest Result Screen
Autotest Results Menu Autotest Results Menu
When the measurement sequence has finished, one of the two Autotest Result screens is displayed (as
shown above). If only a single band test has been completed then the „Other Band“ key will not be
present and the Handover step will not have been attempted as is indicated in the first menu. From this
screen it is possible to redo the measurements ("Restart" key), return to the Autotest Start menu ("Start
Menu"), display the measurement results in place of the pass/fail indicators ("Values") or to print a test
report ("Print Report").
Restart
Press this key to repeat the measurement sequence.
Start Menu
Press this key to return to the Autotest Start menu.
Meas
Press this key to display the Power Ramp menu. From within the Power Ramp menu the Phase Freq
menu can be selected.
Other Band
This softkey is only visible after a two band autotest sequence has been attempted. Press this key to
display the other GSM band that has been used for the Autotest sequence
.
Values
Pressing this key switches from pass/fail indications to the actual test values. After the values are
displayed the used tolerances can be indicated by pressing this key. If the test is carried out on three
channels the signalling results (LocUpd, Call to ...) are displayed in a separate menu. This menu is also
accessed using this key.
Print Report
Pressing this key will generate either a one page or two page test report. A pass/ fail report will be
printed when the „Pass/Fail“ results menu is viewed and a values report when the „Values“ results menu
is viewed.
When a two band Autotest sequence has run to conclusion, then a two page report, that has results for
both test bands will be produced if requested. If the Autotest sequence has tested only a single band
then only a one page report containing results for that band will be printed if requested.