Rohde & Schwarz 1094.0006.50, Operating Manual

Page: 186 / 374

Software Options CTS55
1094.0006.55 12.2 E-3
12.3 Setting the Serial Number
To set the serial number, firstly enter the "Enable S/W Options" menu via the main configuration menu.
Enable S/W Options Menu
The serial number is normally entered into the CTS on the production line and can be seen on the
"Enable S/W Options" menu. If this is not the case there will be a softkey labelled "Serial Number"
present. There is no need to enter the serial number again if it is already set.
To enter the serial number, press the "Serial Number" softkey which will move the system into the
"Serial Number" menu.
Serial Number Menu
The serial number can be found on the rear panel of the CTS and uses the format of <xxxxxx/xxx>, for
example <123456/789>. Enter this serial number using the softkeys. If the format of the entered serial
number is wrong you will be informed via a message.
Important: The serial number can only be entered once and thereafter cannot be edited.