Windows
Application CTSgo
CTS-K6
1079.2001.01
24
E-3
6.3.1 Sequence Control of Autotest
With the CTSgo program, the autotest mode is called. The sequence control is in the stop mode so
that you can perform the configurations that are still needed. In this mode, you may choose between
the following possibilities:
Observe the appearance of the described block in the toolbar during autotest control.
Note:
Commands of the menu bar can only be called in stop mode. After the change to the stop mode, the
sequence control is reset. Restarting the sequence control restarts the autotest.
The single-step com-
mand changes the
appearance of the con-
trol block. The sequence
control stops when the
single step is terminated.
The program is in the
stop mode. The autotest
is started when the start
command is executed.
The program is in the test
mode. When the wait
command is called, the
program stops after the
next single step.
The program is in the
wait mode. You have the
choice to continue with
the next step or to
change to the test mode
with the single-step
command or the wait
command.
The program is in the test
mode. In this mode, the
tests can be stopped with
the stop command. The
sequence control
assumes its initial state.
The control block does
not change before the
single step is terminated.
Summary of Contents for 1094.0006.50
