Rohde & Schwarz 1094.0006.50, Operating Manual

Page: 339 / 374

CTS-K6 Windows

Application CTSgo
1079.2001.01 83 E-3
7.7.3 Timing
This dialog permits to define the tolerance limits for the jitter and timing measurements. The entered
values are set by pressing OK. If newly entered values should not be set, terminate the dialog with
Cancel.
Set limits are indicated in the second and third column of the measurement report. Refer to the report
section shown below.
Note:
Theoretically, the interval between two transmit bursts of a fixed part is ten milliseconds. The
measured deviation from this ideal value constitutes the timing. To be able to perform this
measurement correctly, it is necessary to average over several bursts. In parallel to the average-value
generation, the minimum and maximum time interval between two bursts is determined. The difference
between minimum/maximum and average value is referred to as negative/positive jitter.
Fig.: Limits Timing dialog window
Fig.: Extract from the Timing measurement report