Rohde & Schwarz 1094.0006.50, Operating Manual

Page: 346 / 374

Windows

Application CTSgo CTS-K6
1079.2001.01 90 E-3
8.2 Output of Measurement Information in the Report
When a call is set up by the mobile, the call number is entered in the measurement report. You can
implement a simple keyboard test.
The information on the individual measurements is indicated in five columns. The first column
describes the measurement and, if required, certain measurement conditions, eg the number of bursts
or frames or the CTS output power used.
Limits used for obtaining the decision Passed / Failed are indicated in the next two columns. A gray bar
is shown if there is no upper or lower limit for the measurement. For instance, setting a lower limit for a
BER measurement would not make sense. The measured value is indicated in column four. Values for
passed tests are displayed in green and a hook appears in the last column. Red values indicate that
the test failed and a red bar is displayed in column five. Tests not performed are displayed in blue in
column four. This may happen when synchronization is lost during the measurement. Information on
the power control level (PCL) and employed channel or the associated test set are indicated in the first
column instead of the modified parameters. This additional information is written in italics.
You can include a simple echo test in the measurement, the result of which is indicated below.
Fig.: Display of call number
Fig.: Output of measurement information in the report
Fig.: Display of echo test