Rohde & Schwarz 1094.0006.50, Operating Manual

Page: 184 / 374

Remote Control CTS55
1094.0006.55 11.24 E-5
Example 2: Set RF generator in Module Test
Send the following commands to the CTS via a terminal program
Command Comment
proc:sel modidle go to state "MODIDLE"
proc:sel iqspec select IQ Spectrum
proc:sel rfg select rf generator
conf:rfg:freq 950 MHz set rfg to 950 MHz
conf:rfg:pow -60 dBm set rf level at RFINOUT
conf:rfg:lev on and switch it on
conf:rfg:freq:off 67 kHz set frequency offset
conf:rfg:dm:form 0 set midamble (training sequence) = 0
conf:rfg:dm:mode dummy modulation = dummy bursts
conf:rfg:ramp:stat on set ramping = on
Use a spectrum analyzer to check the output signal at connector RFINOUT.
(center = 950 MHz, span = 1 MHz, Reflev = -60 dBm)