Rohde & Schwarz 1094.0006.50, Operating Manual

Page: 321 / 374

CTS-K6 Windows

Application CTSgo
1079.2001.01 65 E-3
7.5 Configuration Menu in the DECT Autotest
7.5.1 PP Base Settings
This command permits to call the “PP Base Settings“ dialog window. Use this dialog to adapt the test
mode to the parameters of your portable part. The portable part can only be tested if the RFPI of the
DUT is known. Enter this RFPI in the respective field. In order to test a set consisting of portable part
and fixed part the RFPI from the FP test can be used. To do so, note the description of the FP base
settings in this manual. In the two following fields, you can enter the channel and the slot of the dummy
bearer generated by the CTS. The dummy bearer is the carrier to which a portable part is synchronized
after it has been switched on. The Q-packages of the MAC level are sent from the CTS during the PP
test. These are three binary packages Q0, Q3 and Q6. The associated values can be entered as
hexadecimal values. The QMUX indicates the transmission sequence of the packages. A value of
“03060306“ means that first a Q0, then a Q3, a further Q0 and then a Q6 package, etc. are sent.
Further information on Q-package messages can be obtained from the ETSI standard ETS 300-175
Part 3. Finally, for compensation of RF losses, you can enter attenuation values for the input and
output in the respective. The CTS will then convert its output level and the measured output power of
the mobile accordingly.
Fig.: Configuration menu in the
DECT autotest