Rohde & Schwarz 1094.0006.50, Operating Manual

Page: 278 / 374

Windows

Application CTSgo CTS-K6
1079.2001.01 22 E-3
The following elements are displayed to the right of the time of the day:
Status indication of program sequence. The status check in the sequence control is made
periodically. With each performed cycle the icon is rotated by 90°. Events on the serial interface
also cause the icon to move. If the icon does not rotate, the Windows system is overloaded. In this
case terminate all other programs, if required, also terminate and restart CTSgo.
Status information on CTS operating status. In some sequences of the autotest, the sequence
control queries the CTS operating status. Each icon corresponds to a specific status of CTS. The
device states shown below are described in the remote-control section of the CTS manual. The red
lamp indicates an undefined device status.
IDLE (switch-on status of CTS).
MIDL (BCCH being generated).
MSYN (Location Update terminated).
MCE (call set up).
A progress bar to the right of the CTS status icon informs the user on
the status of the serial interface. At each write and read event the bar
is started from the left side. The end position of the bar at the right is
reached when a timeout of the remote-control interface occurs. This
maximum waiting time for an interface response can be configured by
the user.
Pressing the righthand mouse key in the autotest dialog window opens
a popup menu , where previously entered parameter sets can be
stored as configuration files for reloading later on. The paths of up to
eight stored configuration files are displayed. Move to the desired entry
with the righthand mouse key held down and then release the key.
The selected file is loaded and the name of the selected configuration
file is displayed in the title bar.
The interaction of the mobile phone and autotest is indicated in the Message field. The following
animated icons are used:
The test expects the mobile to synchronize to the base station signal of the CTS.
The mobile rings and waits for call pick-up. This status is shown by a to and fro movement
of the displayed handy.
The transmitter and receiver tests are in progress.
You are requested to terminate the call. The left key on the mobile shown in red flashes
during animation.
Fig.: Popup menu in GSM
autotest dialog