Rohde & Schwarz 1094.0006.50, Operating Manual

Page: 329 / 374

CTS-K6 Windows

Application CTSgo
1079.2001.01 73 E-3
The following TX measurements are available:
•
NTP (Normal Transmit Power)
•
Power ramp (Template)
•
Graphics burst display in the appendix to the measurement report
•
Frequency offset
•
B-field modulation
•
Graphics display of modulation in the appendix to the measurement report
•
Frequency drift
•
Jitter
•
Acoustic echo test
For these measurements, the RF output level of the CTS is to be entered in the RF Level field for the
TX measurements. Besides, the number of bursts to be sent is defined for power and modulation
measurements or the number of bursts to be sent for the timing measurements.
Note:
This command can only be called if PP test set 1 is activated for the tests.
7.5.11 PP Test Set 2
You can determine the tests to be performed for the specified TCH channel. For more details refer to
the description of test set 1.
Note:
This command can only be called if PP test set 2 is activated for the tests.
7.5.12 PP Test Set 3
You can determine the tests to be performed for the specified TCH channel. For more details refer to
the description of test set 1.
Note:
This command can only be called if PP test set 3 is activated for the tests.
7.5.13 PP Test Set 4
You can determine the tests to be performed for the specified TCH channel. For more details refer to
the description of test set 1.
Note:
This command can only be called if PP test set 4 is activated for the tests.
7.5.14 PP Test Set 5
You can determine the tests to be performed for the specified TCH channel. For more details refer to
the description of test set 1.
Note:
This command can only be called if PP test set 5 is activated for the tests.