QMS 1060, User Manual

Page: 7 / 311

Contents v
Printer Start-Up Options ............................................................ 4-87
Enabling/Disabling the Start-up Page 4-87
Enabling/Disabling the SYS\START File 4-88
Loading the PostScript Error Handler 4-88
Special Pages ............................................................................. 4-88
Using the Calibration Page 4-89
Working with Status Pages 4-89
Working with Header Pages 4-91
Working with Trailer Pages 4-92
Timeouts ..................................................................................... 4-93
Setting an Emulation Timeout 4-93
Setting an ESP Timeout 4-94
Setting a PostScript Emulation Timeout 4-94
Setting a Print Job Timeout 4-94
Setting a Manual Feed Timeout 4-95
5 Additional Technical
Information
Introduction .................................................................................. 5-2
Communication Modes ................................................................ 5-2
About Gamma Correction ........................................................... 5-3
Terms 5-3
Gamma Correction Concept 5-6
A Special Note for QuarkXPress Users 5-7
Memory ......................................................................................... 5-8
QMS Memory Management 5-9
Memory Terms 5-9
Evaluation of Your Printing Environment 5-12
Memory Clients 5-14
End Job Mode ............................................................................. 5-22
Common Reasons to Use End Job Mode 5-23
Using the EOD Commands 5-24
Setting the End Job Mode for the Serial and Parallel Protocols 5-24
Setting the End Job Mode via the Control Panel 5-25
Adding an EOD Command to Your File 5-27
Creating a Network Job Separator 5-29