QMS 1060, User Manual

Page: 210 / 311

Storage
Options
QMS 1060 Print System Reference 6-44
1 Turn off the printer, and then disconnect the power cord
and all interface cables (parallel, serial, and Ethernet) from
the printer.
2 Remove the two
screws from the
optional I/O interface.
» Note: Save the two
screws. (You’ll use them
when you install the
board.) You can either
save or discard the
plate.
3 Access the printer controller board.
Use the instructions in the “Removing the Controller Board”
section of this chapter.
4 If you are installing an internal hard disk at this time, use
the instructions in the , “Installing an Internal IDE Hard
Disk” section, later in this chapter, and then return to step
“Attach the IDE-SCSI board.” on page 45.
If you already have an internal IDE hard disk installed and you
want to remove it, follow the directions in the “Removing an
Internal IDE Hard Disk” section, later in this chapter.