QMS 1060, User Manual

Page: 179 / 311

Reinstalling the
Controller
Board
6-13 Printer Options
1 Replace the controller board in the printer.
Lift the controller board and position it on the guide rails inside the
printer so that the optional network interface ports are on the left-
most edge of the rear of the printer.
» Note: Align both the top and bottom guide rails, before sliding the
board in the printer. Align the bottom guide rail first, and then
align the top guide rail making sure that the board is aligned
properly on both rails before sliding it into the printer.
2 Slide the controller board in until it is firmly seated in the
printer.
3 Replace the 2 screws you removed earlier.
4 Reconnect all interface cables and the power cord, and then
turn on the printer.
Bottom Guide Rails
Top Guide Rail