QMS 1060, User Manual

Page: 206 / 311

Optional
Network
Interfaces
QMS 1060 Print System Reference 6-40
1 Turn off the printer, and then disconnect the power cord and
all interface cables (parallel, serial, and LocalTalk) from the
printer.
2 Access the printer controller board.
Use the instructions in the “Removing the Controller Board” sec-
tion of this chapter.
3 Remove the two screws from one of the optional interface
plates on the back of the printer.
You can use either of the optional interface ports.
Save the two screws. (You’ll use them when you install the net-
work interface card.) You can either save or discard the plate.
4 Attach the NIC
a Position the network interface card (NIC) so the port slides
into the opening you just created.
b Snap the NIC onto the 80-pin connector on the controller
board.
c Press down on the board gently until it is secured by the 80-
pin connector.
5 Replace the controller board.
Use the instructions in the “Reinstalling the Controller Board” sec-
tion of this chapter.
80-pin
connector