QMS 1060, User Manual

Page: 215 / 311

Storage
Options
6-49 Printer Options
3 Remove the controller board.
Use the instructions in the “Removing the Controller Board” section,
earlier in this chapter.
4 Unsnap the board from the 80-pin connector on the controller
board and pull it away from the I/O opening.
5 Slide the IDE-SCSI board out of the I/O opening.
6 If you have an IDE hard disk installed, you must remove it as
shown in the “Removing an Internal IDE Hard Disk” section, later
in this chapter.
If you do not have an IDE hard disk installed, return to step “Attach
the IDE-SCSI board.” on page 45 of the “Installing an IDE-SCSI
Board” section, earlier in this chapter.
1 Turn off the printer, and then disconnect the power cord and all
interface cables (parallel, serial, Ethernet, and SCSI) from the
printer.
2 Remove the two screws
from the optional I/O inter-
face on the controller board.
» Note:
Save these screws.
(You’ll use them when you
reinstall the board.)